JCB, SO53 3LE
www.JCBDIY.com
Customer Helpline 0333 0143092
OPERATING INSTRUCTIONS
NOTE:
Before using the tool,
read the safety and operating
manual carefully.
INTENDED USE
The machine is intended for hammer
drilling in concrete, brick and stone
as well as for light chiseling work.
It is also suitable for drilling without
impact in wood, metal, ceramic and
plastic.
1. INSERTING/REPLACING
THE DRILL CHUCK (See A)
●
Inserting the Drill Chuck
To work with tools without SDS-plus
(e.g., drills with cylindrical shafts),
a suitable drill chuck must be used.
Insert the adapter (11) of the drill
chuck (10) with a twisting motion
into the SDS-plus chuck (9) until it
can be heard to lock. The adapter
locks itself. Check the locking by
pulling on the drill chuck.
●
Removing the Drill Chuck
To remove the drill chuck (10), pull
the locking sleeve (7) to the rear,
hold in this position and remove the
drill chuck from the tool holder.
2. INSERTING AND
REMOVING DRILL BIT IN
SDS
Take care that the dust protection
cap (8) is not damaged when
changing tools.
●
INSERTING
A
10
11
