JCB, SO53 3LE
www.JCBDIY.com
Customer Helpline 0333 0143092
base plate and angle plate (8)
superposition at the desired angle
(0, 15, 30, 45) (See I). For other mitre
angles, rotate to your desired angle
(use a protractor scale). Following
one of the above procedures, hold
the base plate in position and firmly
tighten the bolts to clamp the base
plate at that angle. Finally, check the
angle and ensure the base plate is
firmly clamped. The angle markings
on the base plate are accurate for
most general purposes but it is
recommended for accurate work to
set the angle with a protractor and
make a test cut on other material.
11. DUST TUBE (See J)
Mount the dust tube (6) into the
opening of the base plate (7).
Make sure that the plastic tip of the
vacuum connection engages into
the corresponding opening on the
housing as shown in the figure.
12. PROTECTION FINGER
WIRE
The finger wire is located in front of
the blade holder. Whilst working, it
will help prevent accidental contact
with moving blade.
1
3. DUST BLOWER AIR
HOLE
This is a small aperture located
underneath the housing just behind
the blade guide. Ensure this is
kept clean to allow the air flow to
H
8
I
8
7
6
J
