20
JCB-MS-254SB
Instruction & User Manual
•
Tighten the set screw (16b) again.
•
Move the machine head (4) to its upper
position.
•
Use the handle (1) to push back the
machine head (4) and fix it in this position if
required (dependent on the cutting width).
•
Place the piece of wood to be cut at the
stop rail (16) and on the turntable (14).
•
Lock the material with the clamping device
(7) on the fixed saw table (15) to prevent
the material from moving during the cutting
operation.
•
Push down the release button (3) to release
the machine head (4).
•
Press the ON/OFF switch (2) to start the
motor.
•
With the drag guide (21) fixed in place:
•
use the handle (1) to move the machine
head (4) steadily and with light pressure
downwards until the saw blade (6) has
completely cut through the work piece.
•
With the drag guide (21) not fixed in place:
•
pull the machine head (4) all the way to
the front. Lower the handle (1) to the
very bottom by applying steady and light
downward pressure. Now push the
machine head (4) slowly and steadily to
the very back until the saw blade (6) has
completely cut through the work piece.
•
When the cutting operation is completed,
move the machine head (4) back to its
upper (home) position and release the ON/
OFF button (2).
Attention! The machine executes an upward
stroke automatically due to the return
spring, i.e. do not release the handle (1)
after completing the cut; instead allow the
machine head to move upwards slowly
whilst applying light counter pressure
All manuals and user guides at all-guides.com
Summary of Contents for MS-254SB
Page 2: ...2 JCB MS 254SB Instruction User Manual All manuals and user guides at all guides com...
Page 30: ...30 JCB MS 254SB Instruction User Manual All manuals and user guides at all guides com...
Page 32: ...32 JCB MS 254SB Instruction User Manual All manuals and user guides at all guides com...
