jcb RS T4F, Quick Start Manual

16

Please consult your manual for full information or consult your local dealer.

Control panel – DSE 8610

Fig 9

This button places the module into its STOP/RESET mode. This will clear any alarm 
conditions for which the triggering criteria have been removed. If the engine is running 
and the module is put into STOP/RESET mode, the module will automatically instruct the 
generator to unload (‘Close Generator output’ becomes inactive. In STOP/RESET mode 
the generator remains at rest.

This button places the module into its MANUAL mode. Once in MANUAL mode, the 
module responds to the start button to start the generator and run it off load. To place 
the generator on load, use the ‘Transfer to Generator‘ button. The module automatically 
instructs the generator to synchronise and once in sync, to be place the generator on 
load (‘Close Generator Output’ becomes active). To place the generator off load, use the 
‘Open Generator‘ button. The module automatically ramps the load off the generator and 
then takes it off load (‘Close Generator Output’ becomes inactive). Additional digital inputs 
are available to perform these functions. If the generator is running off-load in MANUAL 
mode and on load signal becomes active, the module automatically instructs the generator 
to synchronise and once in sync, to be place the generator on load (‘Close Generator 
Output’ becomes active). Upon removal of the on load signal, the generator remains on 
load until either selection of the ‘STOP/RESET’ mode or ‘AUTO’ mode.

A

  Module display 

B

   Four configurable status LED 

C

   Close generator 

D

   Generator available LED 

E

   Start button 

F

   Alarm mute and lamp test 

G

   Auto mode 

H

   Generator breaker LED 

J

   Manual mode 

K

   Stop/reset button 

L

   Selected mode indication LED 

M

   Open generator (manual mode 

only) 

N

   Module display Menu  

navigation buttons

A

B

C

E

F

G

H

J

K

M

L

N

D