jcb TM320, Operator'S Manual

Introduction

Safety Check List

11

11

9821-3100-6

!M

WARNING

Fires

If your machine is equipped with a fire extinguisher,
make sure it is checked regularly. Keep it in the correct
machine location until you need to use it.

Do not use water to put out a machine fire, you could
spread an oil fire or get a shock from an electrical fire.
Use carbon dioxide, dry chemical or foam
extinguishers. Contact your nearest fire department as
quickly as possible. Firefighters should use self-
contained breathing apparatus.

INT-3-2-7_2

!M

WARNING

Should the machine start to roll over, you can be
crushed if you try to leave the cab. If the machine
starts to roll over, do not try and jump from the cab.
Stay in the cab, with your seat belt fastened.

INT-2-1-12

!M

WARNING

Entering/Leaving

Entering or leaving the cab or canopy must only be
made where steps and handrails are provided. Always
face the machine when entering and leaving. Make
sure the step(s), handrails and your boot soles are
clean and dry. Do not jump from the machine. Do not
use the machine controls as handholds, use the
handrails.

INT-2-1-7_1

Maintenance Safety

!M

WARNING

Communications

Bad communications can cause accidents. If two or
more people are working on the machine, make sure
each is aware of what the others are doing. Before
starting the engine make sure the others are clear of
the danger areas; examples of danger areas are: the
rotating blades and belt on the engine, the
attachments and linkages, and anywhere beneath or
behind the machine. People can be killed or injured if
these precautions are not taken.

INT-3-1-5

!M

WARNING

Repairs

If your machine does not function correctly in any way,
get it repaired straight away. Neglect of necessary
repairs could result in an accident or affect your
health. Do not try to do repairs or any other type of
maintenance work you do not understand. To avoid
injury and/or damage get the work done by a specialist
engineer.

GEN-1-5_2

!M

WARNING

Metal Splinters

You can be injured by flying metal splinters when
driving metal pins in or out. Use a soft faced hammer
or copper pin to remove and fit metal pins. Always
wear safety glasses.

INT-3-1-3_2

!M

WARNING

Electrical Circuits

Understand the electrical circuit before connecting or
disconnecting an electrical component. A wrong
connection can cause injury and/or damage.

INT-3-1-4