P/N 960-000175R_Rev. A {EDP #233426}
© 2014, JAPAN CASH MACHINE CO., LTD.
6
Series Banknote Validator (DBV-400) Integration Guide
2 SPECIFICATIONS
Technical Specifications
Environmental Specifications
Table 4
DBV-400 Technical Specifications
Acceptance Rate
*
:
*. Refer to the specific Country’s “Software Information Sheet” for each Country’s particular Banknote acceptance rate.
98% or greater
Note: The following banknote types are excluded:
•
Banknotes with unclear graphics
•
Double (dual) Notes
•
Worn, dirty, wet, stained, torn or excessively wrinkled Banknotes
•
Banknotes having folded corners or edges
•
Banknotes having the wrong cut dimensions or printing displacement
•
Returned Banknotes because of incorrect or failed insertion.
Banknote Types Accepted:
•
Long side: 110 - 160mm (4.33 - 6.29 in.)
•
Short side: 60 - 72mm (2.36 - 2.83 in.)
Insertion Direction:
Four Ways
†
†. Refer to the specific Country’s “Software Information Sheet” for each Country’s particular Banknote insertion direction.
Processing Speed
‡
:
‡. Excluding Host Communication time lag (Power Supply: +12V DC, Temperature: 25º C ±5º C, Humidity: 30%-60%).
Approximately 2 seconds
(from Banknote insertion to next Banknote insertion)
Validation Method:
Optical Sensor (Transmissive/Reflection)
Diagnostic Indicators:
Bezel Insertion Slot Display: Full-Color + Light Amount DA Control
Status LED: Full-Color
Escrow:
1 Note
Anti-stringing Mechanism:
Optical Detection and Internal Cash Box Lever
Cash Box Capacity
**
:
**.The number of Notes stacked depends on the Banknote’s condition.
Approximately 300 notes (New Banknotes)
Approximately 500 notes (New Banknotes)
Approximately 1000 notes (New Banknotes)
Cash Box Access:
Rear Access
Sleep Mode
††
:
††.Both Mode A and Mode B can be available at the same time.
Mode A: Host Wakeup Mode
Mode B: Entrance Sensor Wakeup Mode
Interface
‡‡
:
‡‡.The Interface Harness connecting to the Host should be less than 3m(9.84 ft).
Photo-Coupler Isolation
TTL
RS232C
Pulse Interface
USB (USB Specification Rev. 2.0 Compliance) (Full Speed/12Mbps)
Table 5
DBV-400 Environmental Specifications
Operating Temperature:
-15ºC to +60ºC (5ºF to 140ºF)
*
*. Depends on hydrothermal conditions.
Storage Temperature:
-20ºC to +60ºC (-4ºF to 140ºF)
*
Relative Operating Humidity:
15% to 90% RH (non-condensed)
Relative Storage Humidity:
15% to 90% RH (non-condensed)
Visible Light Sensitivity:
Avoid contact with direct sunlight
(Interior lighting must be incandescent with a
Radiant Angle of 15 Degrees or more having an Illumination index of 3000 Lux or less)
Installation:
Indoors Only
