P/N 960-100929R_Rev. 3 {EDP #148849}
© 2012, Japan CashMachine Co., Limited
2 - 1
Next-Generation Banknote Acceptor Unit
S e c t i o n 2
This section provides installation and operating
instructions for the iVIZION
®
Series Next-Gen-
eration Banknote Acceptor Unit. The information
within contains the following features:
• Installation Process
• DIP Switch Configurations
• Connector Pin Assignments
• Preventive Maintenance
• Clearing Banknote Jam
• Cleaning
• Interface Schematic
• Operational Flowchart.
I
NSTALLATION
P
ROCESS
Mounting holes are provided in each Frame Unit to
attach the iVIZION
®
to a related Machine during
installation. Select and perform the following steps
to install the iVIZION
®
Unit in the related
Machine’s particular Frame configuration:
1. Install the Interface Harness to the Frame
Grounding Plate (FG PLT) (See Figure 2-1 a)
using the two (2) Floating Collars (See Figure 2-
1 b), the single (1) M2.6x12 W Washer
(See Figure 2-1 c), the single (1) M2.6x10 W
Washer (See Figure 2-1 d) and the single (1)
M2.6 Nylon Nut (See Figure 2-1 e) onto the
Frame Assembly. See the Figure 2-1 circled inset
to visually see the assembly completed as
required.
2. When a side mounting configuration is preferred,
bolt the left and right side of the
iVIZION
®
Frame into its intended
related Machine’s
loca-
tion using six (6) M4 Screws on both sides of the
Frame (3 Screws on each side as shown in Figure
3. When an end mounting configuration is pre-
ferred, remove the Cash Box and bolt the rear end
of the
iVIZION
®
Frame into its intended loca-
tion using four (4) UNC6-32 Flat Head Screws
from inside the back end of the Frame as shown
in Figure 2-3.
When installing the iVIZION
®
Unit into the Host
Machine, refer to the Figure 1-7 “iVIZION SS Ver-
sion Unit Installation and Maintenance Space
Requirements Diagram” on page 1-10 of Section
1 of this Manual.
2 INSTALLATION
a
b
b
c
d
e
Figure 2-1
Interface Harness Installation Location
Figure 2-2
M4 Screws Locations (Left/Right Side)
Figure 2-3
Flat Head Screws Locations (Rear
Side)
NOTE: The length of the M4 Screws should
be pre-selected so they do not puncture the
Plastic Surface of the iVIZION
®
Frame
when a side mounting configuration is
preferred.
