P/N 960-100929R_Rev. 3 {EDP #148849}
© 2012, Japan CashMachine Co., Limited
6 - 2
Section 6
iVIZION® SeriesNext-Generation Banknote Acceptor Unit
Calibration and Testing
5. Mouse-click on “
Next>
” Screen Button
Destination Folder
”
Screen shown in Figure 6-6 appears.
6. Check the “
Current Settings:
7 a) and then Mouse-click on the “
Install
” Screen
Button (See Figure 6-7 b) to start the installation.
7. Once installation is complete, the “
InstallShield
Wizard Completed
” Screen shown in Figure 6-8
will appear.
8. Mouse-click on the “
Finish
” Screen Button to
end the installation process.
This completes the “
JCM Tool Suite Standard Edition
”
installation procedure.
Driver Installation Procedure
Perform the following steps to install the various
iVIZION
®
Software Drivers (Refer to Figure 6-1
for the Tool Requirements and Harness Connector
locations). Before downloading the iVIZION
®
USB Driver the “
usbivizion.inf
” application must be
installed in a designated Folder on the PC first.
allows:
1. Connect the USB Cable to the iVIZION
®
Unit.
2. Supply power to the iVIZION
®
Unit.
3. The
“
Hardware Update Wizard
” Screen shown in
Figure 6-10 will appear. Mouse-click on the
Radio Screen Button
located beside “
No,
not this time
Mouse-click on the “
Next>
” Screen Button
(See Figure 6-9 b).
4. When the Screen shown in Figure 6-10
appears, Mouse-click on the Radio Screen
Button
located beside “
Install the software
automatically (Recommended)
”
line (See Figure 6-
10 a), and then Mouse-click on the “
Next>
” Screen
Figure 6-5
Customer Information Screen
b
a
NOTE: The “
OEM
” in “
Last Name:
” and
“
Organization:
” fields are default settings.
The actual “Last Name” and “Organization
Name” is available for a Customer’s use.
Figure 6-6
Destination Folder Screen
a
Figure 6-7
Current Settings Confirmation
b
a
Figure 6-8
Installation Completion Screen
a
Figure 6-9
Hardware Update Wizard Screen 1
a
b
