P/N 960-000186R_Rev. A {EDP #253995}
© 2016, JAPAN CASH MACHINE CO., LTD.
5
RDM-100™ Series Retail Deposit Module
2 SPECIFICATIONS
Technical Specifications
Table 2
RDM-100 Technical Specifications
Acceptance Rate
*
:
*. Refer to the specific Country’s “Software Information Sheet” for each Country’s particular Banknote acceptance rate.
99% or greater (Accept Priority Mode: 99.9% or greater
†
)
The following banknote types are excluded:
•
Banknotes with excess or poor magnetism or unclear graphics
•
Double (dual) Notes
•
Worn, dirty, wet, stained, torn or excessively wrinkled Banknotes
•
Banknotes having folded corners or edges
•
Banknotes having the wrong cut dimensions or printing displacement
•
Returned Banknotes because of incorrect or failed insertion.
†. In this case, acceptable country has priority.
Acceptable Denomination:
200 Denomination Maximum
Banknote Types Accepted:
•
Long side: 110-177mm (4.33-6.97 in.)
‡
•
Short side: 60-85mm (2.36-3.35 in.)
‡. Use the other return tray if the Long Side is greater than 160mm.
Insertion Direction:
Four-Way
Bulk Feed:
Approximately 250 Notes Maximum (US Dollar/New Banknote)
Processing Speed:
6 Notes per second (150mm Banknotes)
Return Tray Capacity:
Approximately 20 Notes Maximum
Separate Cash Box
**
Usable:
**.Separate Cash box is supplied by the OEM.
Cash Box Transport Path guides the Banknote into Cash Box and is
attached with screws from the upper surface or from inside the Cash Box
Validation Method:
Refer to “BAU Operation and Maintenance Manual”
Diagnostic Indicators:
LED
Insertion Slot LED: Idle = Green Lit / Insertion = Green Flash
Misaligned = Yellow Flash / Error = Red Flash
Dispense Slot LED: Banknote Detection = Blue Flash
no Banknote = extinguished
Interface
††
:
††.The Interface Harness connecting to the Host should be less than 3m (9.84 ft).
Host: RS232C, USB 2.0 (Full-Speed)
BAU: USB 2.0 (Full-Speed) (for BAU Template Download)
