P/N 960-100925R_Rev. A {EDP #186705}
© 2010, Japan CashMachine Co, Limited
1 4
Transaction Based Validator Integration Guide
8. If necessary, remove the Cash Box (See Figure 13
a) from the Frame, and remove the jammed Bank-
note as shown in Figure 13b (Review Figure 9
“Removing the Cash Box” on page 13 of this
Guide if necessary to properly remove the Cash
Box).
The Banknote jam clearing operation is now
complete.
Cleaning Procedure
To clean the TBV Validation Section, gently rub the
Sensors and Rollers clean using a dry, soft, lint-free
cloth.
Do not use any Alcohol, solvents, citrus based
products or scouring agents that may cause damage
to the Validation Section Sensors and Rollers.
Sensor and Roller Cleaning Procedure:
1. Turn the TBV and Host Machine’s Power
Supply’s
OFF
.
2. Open the Upper Chassis.
3. Clean the appropriate path and Lens of each
a
” through “
y
” and
the corresponding Table 18 descriptions to locate
each Sensor and Roller that require cleaning.
Remove
Remove
a
b
Figure 13
Removing a Jammed Banknote 3
Caution: Do not use Alcohol, thinner or
citrus based products for cleaning any
surfaces. The Lenses can become
clouded by chemical effect that may
cause acceptance errors.
Use a lint-free cloth soaked with purified
water and wrung dry to clean the
internal surfaces and BNF Rollers only.
