P/N 960-100928R_Rev. 3 {EDP #192692}
© 2018, JAPAN CASH MACHINE CO., LTD.
2 - 9
Installation
UBA-RC™ Series Banknote Recycler
Section 2
Sensor and Roller Locations
Figure 2-10 illustrates the various UBA-RC
™
Unit’s sensor cleaning locations. Table 2-7 lists the
UBA-RC
™
sensor type cleaning methods, respectively.
Table 2-7
UBA-RC Sensor Type Cleaning Methods
Sym.
Sensor Type
Sym.
Sensor Type
Cleaning Method
a
RC2 End Sensor LED
k
RC2 Full Sensor LED
Wipe clean using
a lint-free cloth or
blow clean using
Compressed Air
*
*. Wipe and clean all of the Green colored Rollers and Belts shown in Figure 2-10 using a slightly damp, lint-free, Micro-fiber cloth. Do not allow liquids
or fluids to drip into the Unit, to minimize risk of damage or improper performance.
b
RC1 End Sensor LED
l
Lifter Home Position Sensor LED
c
Recycle Unit Sensor
m Lifter Home Position Sensor PT
d
RC1 Full Sensor PT
n RC2 End Sensor PT
e
Double Notes Detection Sensor LED
o RC2 Full Sensor PT
f
Double Notes Detection Sensor PT
p Transport Sensor 2 Prism
g
RC1 End Sensor PT
q Lifter Home Position Sensor Prism
h
Transport Sensor 1
r
Recycle Unit Sensor Prism
i
RC1 Full Sensor LED
s
Transport Sensor 1 Prism
j
Transport Sensor 2
Figure 2-10
UBA-RC Sensor, Roller and Belt
Figure 2-10
UBA-RC Sensor, Roller and Belt Cleaning Locations
b
a
c
d
f
k
l
f
h
q
r
j
n
p
m
o
g
e
i
e
s
NOTE: Remove the Recycler Unit and clean the enclosed
Blue
rectangular area with Compressed Air.
NOTE: Disassemble the RC Banknote Path Race and clean the Pick
Rollers using a slightly damp, lint-free, Micro-fiber cloth.
NOTE: Clean the Rear Belts using a
slightly damp, lint-free, Micro-fiber
cloth, or use Compressed Air to
blow away any dust. Check that
the Rear Belts are properly
installed before cleaning them.
