P/N 960-100928R_Rev. 3 {EDP #192692}
© 2018, JAPAN CASH MACHINE CO., LTD.
2 - 1 8
Section 2
UBA-RC™ Series Banknote Recycler
Installation
Operational
Flowcharts (Continued 7)
Figure 2-22 depicts a typical UBA-RC
™
Retrieving to Cash Box flow process.
Figure 2-22
C3) Return from the Figure 2-20 “Abnormal Banknote
Detection in Dispensing” Flow on page 2-17 or
from the Figure 2-21 “Retrieving” Flow
on page 2-17 of this Service Manual
b) Is the Banknote being sent to the Cash Box?
f) Is the Cash Box full?
g) Stop transportation and Send a Cash Box Full
Signal (*4)
h) Was the Banknote Stacked during an Abnormal
condition while dispensing?
B2) Return to the Figure 2-19 “Dispensing” Flow on
page 2-16 of this Service Manual
a) Transporting the Banknote to the Cash Box
d) Stop transportation
Send an Abnormal Signal (*2)
i) Were the desired counts of Banknote’s retrieved
during the “Retrieving” sequence?
A) Return to the Figure 2-14 “Primary Sequence”
Flow on page 2-11 of this Service Manual
B3) Return to Figure 2-21 “Retrieving” Flow on
page 2-17 of this Service Manual
e) Stack the Banknote
*2). When an Abnormal Signal is received, Remove and re-supply Power to the UBA-RC after resolving the problem, or send
a RESET Command from the Host Machine
*4). When a “Cash Box Full” Signal is received, retrieve the Banknotes from the Cash Box and re-seat the Cash Box back into
the Unit. The UBA-RC will automatically perform its re-initialization movement operation.
c) Was transportation retried three (3) times?
c
b
f
h
i
a
d
e
g
E
B2
B3
YES
NO
YES
NO
YES
YES
YES
NO
NO
NO
Figure 2-22
UBA-RC Operational Flowchart (Retrieving to Cash Box)
