JCM Part No. 960-000097R_Rev. 3
© 2010, JCM American, Corporation
1 - 3
General Information
Universal Bill Acceptor (UBA-1x-SS & UBA-x4-SS/SU)
Section 1
Use a soft, lint-free cloth and a mild non-
abrasive soap and water solution to clean
dust and debris from the Banknote’s path.
A new JCM authorized Waffletechnology
Cleaning Card is now available for quick
cleaning of the UBA Unit. Refer to page 2-
11 of Section 2 of this Service Manual for
more information on using the Waffletech-
nology Cleaning Card.
8. Inserting worn or damaged Banknotes may
cause a jam. If a jam occurs when the Cen-
tering Mechanism is closed, the Cover will
not open. To unjam the Unit when in this
condition, recycle Power to allow the Unit to
reset. Refer to “Clearing a Banknote Jam” on
page 2-10 of Section 2 of this Service Man-
ual for more information on clearing Ban-
knote jams.
Under no circumstances allow the cloth
to be wet enough to allow excess fluid
to run into the device; internal Printed
Circuit Boards may be damaged. Do not
use any Alcohol, solvents or scouring
agents which can attack the plastic
surfaces of the device.
Figure 1-3
Universal Bill Acceptor (UBA-1X-SS) Major Component Parts
UBA-10/11/12 Component Names
Figure 1-3 illustrates the UBA-10/11/12 Primary Component Parts and their relative locations.
A: Acceptor Unit
B: Upper Guide Access Lever
C: Front Access Door
D: Acceptor Unit Release Lever
E: SS Style Cash Box
F: USB Type B Male Receptacle for software
downloading and adjustments
G: DIP Switch Block (See Table 2-1on page 2-2 of
Section 2 to properly set these Switches)
H: Diagnostic LEDs
(Green & Red)
See Table A-13
and Table A-15 in Section Afor the proper
Diagnostic Codes)
I: Front Bezel Connector
(Connects to the Faceplate Assembly)
J: Interface Connector
(Connects to the Host Machine)
K: Centering Guide Release Port
(on both sides)
L: Housing Frame
M: Key Spacer (2 each)
N: Plate Locking Key (2 each)
O: Key Hole Cap.
