JCM Part No. 960-000097R_Rev. 3
© 2010, JCM American, Corporation
2 - 1 1
Installation/Operation
Universal Bill Acceptor (UBA-1x-SS & UBA-x4-SS/SU) Section
2
If a Bill jam occurs when the centering mechanism
is closed, the cover will not open. To un-jam the
unit, recycle power and allow the unit to reset.
Cleaning/Preventive Maintenance
To clean the lenses, use a lint-free cloth and a mild
non-abrasive detergent such as liquid dish soap
mixed with water. It is important to keep the bill
path, rollers, and belts clean. Use a soft lint-free
cloth or a cotton swab to wipe dirt and stains from
the surfaces of the magnetic and optical sensors,
rollers and belts. The sensor lenses are transparent,
and made of a polymer material. Handle them with
care. Repeat the cleaning process as needed until
the Transport path is free of contaminants
(See Figure 2-18).
Available Cleaning Card
A second generation JCM Waffletechnology Bill
Validator Cleaning Card is now available (JCM
Part No.
501-000180R
, Manufacturer’s Part No.
KWJCM-B2B15M). The cleaning card is designed
to be used as a supplemental part of a Preventive
Maintenance program to help in reducing dirt and
paper dust build-up within a unit. This will opti-
mize performance between regular Preventive
Maintenance intervals. This is the only cleaning
card authorized for use on the UBA Gaming
Validator (See Figure 2-19).
C
ARD
F
EATURES
• A unique Waffletechnology design that hugs
all surfaces to insure complete surface cleaning
• Specially designed scrubber patterns insure
that belts and O-ring rollers are cleaned and
lubricated to prevent them from drying out.
D
IRECTIONS
F
OR
U
SE
1. Remove cleaning card from pouch and insert
it into the Bill Validator.
2. The cleaning card will be accepted and then
automatically feed in-and-out several times.
3. Insert and HOLD cleaning card while the
Validator pulls on it to ensure proper belt
cleaning.
4. Dispose of used card in an environmentally
safe manner.
For more information and a list of Authorized
Waffletechnology Distributers visit:
http://www.jcmwaffletechnology.com.
NOTE: If recycling the power fails to clear
the jam, use a 2.5 mm Hex Nut
Driver (JCM part # 501-000131) to
rotate the mover guide shaft, then
open the Top Cover to remove jam
(See Figure 2-17).
Do not use alcohol, thinner or citrus
based products for cleaning any
surfaces.
Figure 2-18
UBA Cleaning Locations
Figure 2-19
JCM Waffletechnology Cleaning Card
New Cleaning Card
Cleaning Card Pouch
