Installation and connections
Attach the rear part of the housing to the wall using the plugs and screws supplied. Pass the cables through the bottom of the
receiver. Connect the power cables to the terminals marked in the mother board, as indicated. Fix the receiver front to the rear
part using the screws supplied.
Operating
The pilot lights are activated every 5 seconds to indicate the correct supply of power to the equipment. Upon receiving a code,
the receiver checks whether it is in its memory, activating the corresponding relay. The relay activation mode is selected in
either impulse or ON/OFF using the Imp/Bies jumper (only with the relay 2).
For adjustment of relay 1, see manual of the programming tool.
Programming
Manual programming
Press the receiver programming button for 1 sec. and an acoustic signal will be heard. The receiver will enter programming
(see table). If the receiver programming button is held pressed down, the receiver will pass cyclically from one configuration to
the next. Once the programming configuration for the transmitter to be registered has been chosen, send the code to be pro-
grammed by pressing the transmitter. Every time a transmitter is programmed, the receiver will issue an acoustic signal for
0.5 sec. After 10 seconds without programming or pressing the first two transmitter buttons, the receiver will exit pro-
gramming mode, issuing two acoustic signals of 1 sec. If upon programming a transmitter the receiver memory is full, it will
issue 7 acoustic signals of 0.5 sec. and exit programming.
Configuration of transmitter programming in the receiver
LED R1
LED R2
Standard programming
(default option, the receiver always is configured in multichannel)
The relays are activated 1st relay by channel 1 and 2nd relay by channel 2 (3rd
relay by channel 1 and 4th relay by channel 2)
Flashing
Flashing
Special programming
Press the transmitter channel to activate the relay 1 on the receiver
ON
OFF
Press the transmitter channel to activate the relay 2 on the receiver
OFF
ON
Press the transmitter channel to activate the two relays at once *
ON
ON
* If working in ON/OFF activation mode, relay 1 will act as impulse and relay 2 as ON/OFF. Therefore, on the first press relay
1 will close and open the contact and relay 2 will only close. On the second, relay 1 will close and open the contact and relay 2
will open.
Each transmitter can be configured independently on the receiver.
Total reset
In programming mode, the programming button is held down and the “MR” reset jumper is bridged for 3 secs. The receiver will
issue 10 short acoustic warning signals followed by others at a faster pace to indicate that the operation has been successful.
The receiver is now in programming mode. After 10 seconds without programming or quickly pressing the programming but-
ton, the receiver will exit programming mode, issuing two acoustic signals of 1 sec.
jcm
technologies
6
