JCM Technologies FREE 15 R Manual Download

Page: 3 / 4

COD. 1247030-GB / 1.3

FREE 15 R / FREE 30 R

CONFIGURATION OF CHANNELS AND GROUPS

Use the button (4) to configure the activator’s operating mode.

Channel configuration:

Keep the configuration button pressed down until the number of long red signals is equal to the

channel to be configured. For example, if you want to configure channel 2, release the button after the second long red

signal.

Group configuration:

Press the configuration button and keep it pressed down. The led will issue the red channel

configuration signals followed by a series of flashing green signals to indicate that the open group will start the group

selection sequence (long green signals indicating groups 1 to 7). Release the button at the required group. For example, if

you want to configure group 5, release the button after the fifth long green signal.

The procedure can be carried out as many times as required.

Channel: This allows for the channel to be sent to the receiver to be selected.

Group: This allows for the installation of more independently enabled doors (to a total of 22).

Summary of Contents for FREE 15 R

Page 1: ...formed by two parts a compact box 1 with a plastic front part and the wiring outlet at the back and an adhesive trim 2 It is designed to be fitted directly to or built into the wall It is secured by...

Page 2: ...ack Sync IN Green Sync OUT White Wiring diagram for the installation of an activator Where one activator only is to be used the IN and OUT synch signals must be short circuited Wiring diagram for the...

Page 3: ...on button and keep it pressed down The led will issue the red channel configuration signals followed by a series of flashing green signals to indicate that the open group will start the group selectio...

Page 4: ...ccidental activation of the tag when the unit is at a distance greater than 3m from the activator If this happens move the tag or the activator of his current location JCM TECHNOLOGIES S A declares th...