P/N 960-000180R_Rev. 1 {EDP #233427}
© 2016, JAPAN CASH MACHINE CO., LTD.
6 - 1 1
Calibration and Testing
DBV® Series DBV-400 Banknote Validator
Section 6
Feed Motor Test
Perform the following steps to begin the Feed
Motor Test:
1. Launch the Main Screen
(refer to “Performance Test Preparation” on
2. Click
the
“Performance Test” Pull-down Menu,
and select the desired performance test item from
the available selections (Figure 6-48
a
)
(refer to “Performance Test Items Using a PC and
Test Menu Selections” on page 6-10 for a test
item to select).
3. Click
the
“
Start
”
Screen Button (Figure
a
) to begin the test.
4. Confirm that the Feed Motor rotates in the proper
direction and at an acceptable rate of speed
(within approximately 600mm/s to 800mm/s).
The measured speed will appear in the “Motor”
b
).
5. Click
the
“
Stop
”
Screen Button (Figure
a
) to end the test.
Stacking Test
Perform the following steps to begin the Stacking
Test:
1. Launch the Main Screen
(refer to “Performance Test Preparation” on
2. Click the “Performance Test” Pull-down Menu
a
), and select “STACK_TEST”.
3. Click the “
Start
”
Screen Button (Figure
a
) to begin the test.
4. Confirm that the Stacker mechanism movement is
performing a normal rotation.
5. Click the “
Stop
”
Screen Button (Figure
a
) to end the test.
Figure 6-48
Figure 6-48
Feed Motor Test Selections
a
Figure 6-49
Figure 6-49
Feed Motor Test Screen 1
a
Figure 6-50
Figure 6-50
Feed Motor Test Screen 2
a
b
Figure 6-51
Figure 6-51
Stacking Test Selections
a
Figure 6-52
Stacking Test Screen 1
a
Figure 6-53
Stacking Test Screen 2
a
