P/N 960-000180R_Rev. 1 {EDP #233427}
© 2016, JAPAN CASH MACHINE CO., LTD.
2 - 1
S e c t i o n 2
This section provides installation and operating
instructions for the DBV
®
Series DBV-400
Banknote Validator Unit. The following informa-
tion is discussed within this section:
•
Installation Procedure
•
DIP Switch Configurations
•
Connector Pin Assignments
•
Preventive Maintenance
•
Standard Interface Circuit Schematics
•
Operational Flowchart
Installation Procedure
The DBV-400 Frame Unit provides installation
grooves (notches) for each surface.
Entire Unit Installation
Perform the following steps to install the DBV-400
Unit:
1. Place the DBV-400
Unit Frame cut outs (Figure
a
1
through
a
4
and
b
1 &
b
2
) onto the threaded
studs on the chassis.
2. Secure the rear side of the DBV-400 Frame to the
chassis with six (6) nuts.
DIP Switch Configurations
This section provides the DIP Switch Block 1 (
DIP
SW1
) and Block 2 (
DIP SW2
) Settings for the
DBV-400 Unit and its Bezel.
DIP Switch Block 1
DIP Switch Block 1 (
DIP SW1
) is used to Accept
(enable) or Inhibit (disable) acceptance of each
Banknote denomination.
DIP Switch Block 2
DIP Switch Block 2 (
DIP SW2
) is used to set
various functions.
2 INSTALLATION
NOTE: Refer to “Unit Dimensions” on
page 1-8 for each Bezel’s dimensions.
Figure 2-1
Figure 2-1
Threaded Studs Location
50.8
84
116
a
1
a
2
a
3
a
4
b
1
b
2
Chassis Side
Reference Dimensions
Insertion Slot
Area (Open)
Table 2-1
DIP Switch Block 1 Settings
Switch
No.
Switch ON
Switch OFF
1
VEND 1 INHIBIT
VEND 1 ACCEPT
2
VEND 2 INHIBIT
VEND 2 ACCEPT
3
VEND 3 INHIBIT
VEND 3 ACCEPT
4
VEND 4 INHIBIT
VEND 4 ACCEPT
5
VEND 5 INHIBIT
VEND 5 ACCEPT
6
VEND 6 INHIBIT
VEND 6 ACCEPT
7
VEND 7 INHIBIT
VEND 7 ACCEPT
8
TEST MODE
FUNCTION
Table 2-2
DIP Switch Block 2 Settings
Switch No.
Switch ON
Switch OFF
1
Refer to the “Software Information Sheet” for
details on DIP Switch Block 2 (
DIP SW2
) settings.
2
3
4
5
6
7
8
NOTE: Turn the Power Supply to the DBV-
400 Unit OFF before configuring settings on
DIP Switch Block 1 and Block 2.
DS1
DIP SW1
DIP SW2
