P/N 960-000180R_Rev. 1 {EDP #233427}
© 2016, JAPAN CASH MACHINE CO., LTD.
2 - 6
Section 2
DBV® Series DBV-400 Banknote Validator
Installation
ID-002 Pulse Connector Pin Assignments
Table 2-7 lists the DBV-400 ID-002 Pulse Connector Pin Assignments.
Table 2-7
DBV-400 ID-002 Pulse Connector Pin Assignments
CN1 Connector (DBV-400 Side): 74164-0118 (Molex)
Housing (Cable Side): 50-57-9309 SL
™
Crimp Housing, Single Row, Version D, Back Ribs, 9 Circuits (Molex)
015-04-5184 2.54mm SL
™
Interim Clip, 18 Circuits, Polarized (Molex)
16-02-0069 SL
™
Crimp Terminal, Series70058, Female, with Tin (Sn) Plated Contact, 24-30 AWG
(Maximum Insulation Diameter: Less than
φ
1.52) (Molex)
Recommended Wire (for Power Supply and Power Ground): AWG #24 (Maximum Insulation Diameter: Less than
φ
1.52)
Recommended Wire (for Signal Ground): AWG #24 - 30 (Maximum Insulation Diameter: Less than
φ
1.52)
Pin No.
Signal Name
I/O
*
*. I/O (input/output) is the terminal as viewed from the Banknote Validator’s side.
Function
1
+12V - +24V
-
Power Supply
2
GND
-
Power Ground (0V DC)
3
+12V - +24V
-
Power Supply
4
GND
-
Power Ground (0V DC)
5
-
-
Reserved
6
-
-
Reserved
7
-
-
Reserved
8
-
-
Reserved
9
-
-
Reserved
10
GND
-
Signal Ground (0V DC)
11
VEND
OUT
VEND
†
†. The voltage level should be based on the TTL logic levels.
12
-
-
Reserved
13
-
-
Reserved
14
D/E
IN
D/E
†
15
-
-
Reserved
16
BUSY
OUT
BUSY
†
17
ABN
OUT
ABN
†
18
FULL
OUT
FULL
†
1
2
17
18
