176
16.3
SUPERVISOR USING
In case on G-556 the SUPERVISOR is used to give the possibility to control and to execute
operations delicate, the SUPERVISOR will be able to be replace, also during a receipt, not qualified
clerk and to execute the operation in object in order to give again at the operation end, the
continuation of the receipt to the clerk that had begun it.
As an example the SUPERVISOR can replace the clerk that isn't allowed to execute E.C.
operations, SUPERVISOR can execute the E.C. operation and at the end to give back the
continuation of the receipt to previous clerk.
The operations that can be limited in selective mode for each Clerk are:
-
E.C.
-
No Limit
-
VOID
-
PLU price
-
% 1
-
P/O 1
-
% 2
-
P/O 2
-
% 3
-
P/O 3
-
(+)
-
Receipt VOID
-
(-)
-
X reports
-
DRAWER 1 opening
-
Z reports
-
DRAWER 2 opening
-
Daily Z Report (Z--1--Tot.1)
-
R.M.
The SUPERVISOR can replace himself to the Clerk during a receipt by two differents
modalities that depends essentially on the modality of Clerk insertion ; so if the Clerk's modalities
on the ECR is by code, also the SUPERVISOR will have to use its code (6 digits) to replace the Clerk,
while if the Clerk's modalities on the ECR is by mechanical key, the SUPERVISOR can use the key
No.15 (S.S.11F) to replace the Clerk.
In the following examples the execution of an operation of E.C. from the SUPERVISOR.
Clerks and SUPERVISOR by codes :
-
After the several registrations executed by the Clerk, at the attempt from the same one
to execute the operation to which he isn't allowed, the ECR will signal the lack of
qualification by the error E171 - Non authorized.
-
To remove the error by CL key.
-
To press the Clerk key.
-
To input the SUPERVISOR's code (Eg.: 123456).
-
To press the Clerk key again.
-
To press the E.C. key.
-
To continue with the other registrations.
Clerks and SUPERVISOR by mechanical key :
-
After the several registrations executed by the Clerk, at the attempt from the same one
to execute the operation to which he isn't allowed, the ECR will signal the lack of
qualification by the error E171 - Non authorized.
-
To remove the error by CL key.
-
To remove the Clerk mechanical key.
-
To insert the mechanical key of the SUPERVISOR (mechanical key N. 15).
-
To press the E.C. key.
-
To remove the mechanical key of the SUPERVISOR (mechanical key N. 15).
-
To insert again the Clerk's mechanical key with wich has been begun the receipt.
-
To continue with the other registrations.
Note:
The SUPERVISOR can replace itself to the Clerk in order to execute all the
operations delicate indicated above, the SUPERVISOR code will be necessary
also in order to set the ECR in Prg. mode instead than the procedure (4)--Key.
