P/N 960-000164R_Rev. 3 {EDP #213631}
© 2018, JAPAN CASH MACHINE CO., LTD.
4 - 3
Disassembly/Reassembly
iPRO-RC™ Series Banknote Recycler
Section 4
Lifter Motor Assy Removal
To remove the Lifter Motor Assembly, proceed as
follows:
1. Remove the four (4) Mounting Screws (Figure 4-
a
1
to
a
4
) retaining the Lifter Motor Bracket in
b
), and take the Lifter Motor
Bracket off of the Frame.
2. Remove the single (1) E-Ring (Figure 4-7
a
) and
the single (1) Gear (Figure 4-7
b
) from the
Assembly.
3. Remove the two (2) Mounting Screws (Figure 4-7
d
1
&
d
2
) retaining the Lifter Motor Assembly in
place (Figure 4-7
e
), and remove the Lifter Motor
Assembly from the Lift Motor Bracket.
Upper & Lower Full Sensor PT/
Upper & Lower End Sensor
LED Removal
To remove the Upper/Lower Full Sensor PT (Photo
Transistor) and the Upper/Lower End Sensor LED,
proceed as follows:
1. Remove the six (6) Mounting Screws (Figure 4-8
a
1
to
a
6
) retaining the Rear Frame Cover (Figure
b
) to the back side of the Frame.
2. Remove the four (4) Mounting Screws (Figure 4-
c
1
to
c
4
) retaining the Center Shelf in place
d
) and slide it out of the Frame.
Emission Side Double Note Sensor
a
b
c
d
e
Figure 4-5
Emission Side Double Note
Sensor Removal
Figure 4-6
1
a
2
b
a
3
a
4
Figure 4-6
Lifter Motor Bracket Removal
NOTE: Ensure that the Parallel Pin
c
) does not fall out when
removing the Gear.
NOTE: When re-assembling the
Motor, ensure that the Harness is
correctly positioned as shown in
, and that the Encoder
Gear (Figure 4-7
g
) does not touch
either wall of the Sensor (Figure 4-7
h
).
Figure 4-7
a
b
c
d
1
d
2
e
f
g
h
Figure 4-7
Lifter Motor Assy Removal
Figure 4-8
a
2
a
3
a
4
a
5
a
6
b
d
c
3
c
4
c
1
c
2
Figure 4-8
Rear Frame & Middle Frame Removal
