P/N 960-000164R_Rev. 3 {EDP #213631}
© 2018, JAPAN CASH MACHINE CO., LTD.
4 - 4
Section 4
iPRO-RC™ Series Banknote Recycler
Disassembly/Reassembly
3. Tilt the Rear Transport Assembly (Figure 4-9
a
)
backward and out of the Frame.
4. Remove the five (5) Mounting Screws (Figure 4-
a
1
to
a
5
) retaining the Left Frame Plate in place
b
), and separate the Left Plate from
the Frame bottom.
5. Remove the five (5) Mounting Screws (Figure 4-
a
1
to
a
5
) retaining Frame Guide 4 in place (Fig-
b
), and remove Frame Guide 4 from the
Left Frame Plate (Figure 4-11
c
).
6. Remove the four (4) Sensor Covers (Figure 4-12
a
1
to
a
4
); the Upper & Lower Full Sensor PTs
b
&
c
) and the Upper & Lower End
Sensor LEDs (Figure 4-12
d
&
e
) located on the
left side of the Frame from Frame Guide 4, and
then unplug the four (4) related Signal Connec-
tors (Figure 4-12
f
1
to
f
4
) from each Sensor.
Upper & Lower Full Sensor LED/
Upper & Lower End Sensor PT/
Lifter Home Position Sensor LED
& PT Removal
To remove the Upper & Lower Full Sensor LED,
the Upper & Lower End Sensor PT, and the Lifter
Motor Home Position Sensor LED & PT, proceed
as follows:
1. Remove the two (2) Mounting Screws (Figure 4-
a
1
&
a
2
) retaining the UBA/iPRO-RC Internal
Top Frame (Figure 4-13
b
) in place, and take the
UBA/iPRO-RC Internal Top Frame off of the
Right Frame Assembly (Figure 4-13
c
).
2. Remove the five (5) Mounting Screws (Figure 4-
d
1
to
d
5
) retaining Frame Guide 3 (Figure 4-13
NOTE: Be careful that the Harness
is not pinched between the Rear
Transport Assembly and the Frame!
Figure 4-9
Tilt Back and Out
a
Figure 4-9
Rear Transport Assy Removal
Figure 4-10
a
1
a
2
a
3
a
5
a
4
b
Figure 4-10
Left Frame Plate Removal
Figure 4-11
a
1
a
2
a
3
b
c
a
4
a
5
Figure 4-11
Frame Guide 4 Removal
Full Sensor PTs and End Sensor
Figure 4-12
Full Sensor PTs and End Sensor
LEDs Removal
a
1
a
2
a
3
a
4
d
b
f
2
e
f
1
f
3
c
f
4
Figure 4-13
a
2
d
1
b
c
d
4
d
5
d
2
d
3
e
Figure 4-13
Frame Guide 3 Removal
