P/N 960-000164R_Rev. 3 {EDP #213631}
© 2018, JAPAN CASH MACHINE CO., LTD.
4 - 1 1
Disassembly/Reassembly
iPRO-RC™ Series Banknote Recycler
Section 4
O-Ring (Pusher Plate) Removal
To remove the O-Rings on the Pusher Plate,
proceed as follows:
1. Remove the two (2) Mounting Screws (Figure 4-
a
1
&
a
2
) retaining the Pusher Mechanism (Fig-
b
) in place, and slide the Pusher Mecha-
nism out of the Cash Box Frame Housing.
2. Remove the six (6) O-Rings (Figure 4-36
a
1
to
a
6
)
while lifting up on the Pusher Plate (Figure 4-36
b
).
Roller Timing Belt
and O-Ring Removal
To remove the Timing Belt and O-Rings on the
Roller part of the Pusher Plate, proceed as follows:
1. Remove the six (6) Mounting Screws (Figure 4-
a
1
to
a
6
) retaining the Pusher Plate (Figure 4-
b
), and take the Pusher Plate off the Pusher
Mechanism.
2. Remove the five (5) E-Rings (Figure 4-38
a
1
to
a
5
), the two (2) Gears (Figure 4-38
b
1
&
b
2
) and
three (3) Bushings (Figure 4-38
c
1
,
c
2
&
c
3
) from
the Pusher Mechanism Assembly.
3. Remove the three (3) Frame Mounting Screws
e
1
,
e
2
&
e
3
) from the Pusher Mecha-
nism Frame.
NOTE: Position the Impeller on the
slotted portion of the Shaft when re-
installing (Figure 4-34
g
1
&
g
2
).
NOTE: Be sure that the Impeller
wing’s direction is tilted toward the
front, and that both sides of the
wings are set in a parallel position as
shown in the Figure 4-34 re-
assembly illustration. If the wings
are re-assembled in the wrong
direction, it can cause transportation
problems such as a Banknote Jam.
Figure 4-34
Impeller & Stop Roller Removal
a
2
a
1
c
b
d
g
2
e
g
1
f
Figure 4-34
Impeller & Stop Roller Removal
Figure 4-35
a
2
a
1
Figure 4-35
Pusher Mechanism Removal
Figure 4-36
a
2
a
3
a
4
a
5
a
6
b
Figure 4-36
O-Ring Removals
Figure 4-37
a
1
a
2
a
3
a
4
a
5
a
6
Figure 4-37
Pusher Plate Removal
NOTE: Be careful that the Parallel
Pin (Figure 4-38
d
) is not lost while
removing the Gears.
NOTE: One of the Screws is a
Phillips Self Tightening/Tapping type
e
1
). Do not confuse its
placement with the others during re-
assembly.
