P/N 960-000164R_Rev. 3 {EDP #213631}
© 2018, JAPAN CASH MACHINE CO., LTD.
4 - 1 2
Section 4
iPRO-RC™ Series Banknote Recycler
Disassembly/Reassembly
4. Separate Box Gear A (Figure 4-39
a
) from the
Pusher Mechanism, and remove the Timing Belt
inside (Figure 4-39
b
).
5. Remove the two (2) E-Rings (Figure 4-41
a
1
&
a
2
), the single (1) Gear (Figure 4-41
b
), the single
(1) Shaft (Figure 4-41
c
) and the single (1) Bush-
ing (Figure 4-41
d
) from the Pusher Mechanism,
and then remove the Timing Belt from the
Assembly (Figure 4-41
e
).
6. Remove the two (2) Pulleys (Figure 4-42
a
1
&
a
2
)
from the Shaft (Figure 4-42
b
), and remove the
six (6) O-Rings (Figure 4-42
c
1
to
c
6
) from the
individual Pulleys.
Pusher Plate Re-installation
After re-assembling the Pusher Plate onto the
Pusher Mechanism, readjust each Gear position
as follows:
1. Remove the single (1) E-Ring (Figure 4-43
a
)
and the single (1) small Gear (Figure 4-43
b
)
from the Pusher Mechanism (Figure 4-43
c
)
indicated by the
j
Arrow.
2. Rotate the White Gear (Figure 4-43
d
) and the
Black Gear (Figure 4-43
e
) each in the
direction indicated by the
k
Arrows until they
stop rotating.
3. Reinstall the small Gear and its related E-Ring
(removed during Step 1), as indicated by the
l
Arrow.
4. Rotate the White Gear in the direction
indicated by the
m
Arrow, and make sure that
the Home Position Arm (Figure 4-43
f
) meets
the surface of the Pusher Mechanism (Figure
g
).
This completes the iPRO-RC
™
Disassembly and
Reassembly Instructions section.
Figure 4-38
a
1
a
2
a
3
a
4
a
5
b
1
b
2
c
1
2
c
3
d
e
2
e
3
e
1
Phillips Self
Tapping
Figure 4-38
Pusher Drive Gear Removal
Figure 4-39
b
a
Figure 4-39
Pusher Timing Belt Removal 1
NOTE: The Pusher Timing Belt
should be reinstalled as illustrated in
Figure 4-40 when the Unit is being
reassembled.
Figure 4-40
Pusher Timing Belt Replacement
Figure 4-40
Pusher Timing Belt Replacement
a
1
a
2
b
c
d
e
Figure 4-41
Pusher Timing Belt Removal 2
NOTE: Be careful that the Parallel
d
1
&
d
2
) are not
lost while removing the Gears.
a
1
a
2
c
1-3
c
4-6
b
d
1
d
2
Figure 4-42
Pulley & O-Ring Removal
b
a
c
f
e
d
g
Figure 4-43
Pusher Plate Removal
NOTE: If the Gears are not correctly
re-assembled, the Home Position
Arm will not show on the surface.
