P/N 960-000164R_Rev. 3 {EDP #213631}
© 2018, JAPAN CASH MACHINE CO., LTD.
6 - 4
Section 6
iPRO-RC™ Series Banknote Recycler
Performance Tests
10. Highlight select the desired iPRO-RC™ Firm-
ware (Figure 6-17
a
) from the PC Folder.
11. Click on the “
Open
”
Screen
Button (Figure 6-17
b
) to launch the selected file.
12. The “
JCM Downloader Suite Edition Version
X.XX
” Screen will re-appear (Figure 6-18).
If the “
Auto Download Mode
” Check Box
located next to the “
Download
”
Screen
Button (Figure 6-18
a
) is clicked, it will allow the
same iPRO-RC™ Firmware to be downloaded to
another iPRO-RC™ Unit automatically when
Power is supplied to it during the launch of the
JCM Downloader Screen.
The “
Reset
” Pull-down Menu contains the
following three (3) selections:
•
Auto
•
Manual
•
Reset
.
If “
Auto
” is left pre-selected in the “
Reset
” Pull-
b
), the Downloader will
enter Stand-by Mode automatically when down-
loading is complete, and the iPRO™ Transport
Unit LED will then start alternately flashing at a
Green
and
Red
Color rate.
If “
Manual
” is selected from the “
Reset
” Pull-
down Menu, the LED will light a steady
Green
Color when the download is complete.
If “
Reset
” is selected from the “
Reset
” Pull-
down Menu, the Downloader’s Status will be
reset back to Stand-by Mode. The LED will again
begin alternately flashing between a
Green
and
Red
Color rate.
13. Click on the center “
Download
”
Screen
Button (Figure 6-19
a
) to begin a Firmware
download. The LED will begin flashing alter-
nately at a
Green
and
Red
Color Rate while a
download is in progress. The Downloading
Screen will display a
Blue
Progress Bar during
the download operation (Figure 6-19
b
), and a
Blue
Text Line below the “
Download
”
Screen Button will indicate the download Per-
centage as “
Downloading : XX%
” (Figure 6-19
c
).
14. When the desired download is complete, a “
Get-
ting and Verifying CRC and Version information.
”
Blue
Text Line will appear (Figure 6-20
a
), and
Model Information will start being collected.
15. First, a “
Download Success. Validator is reboot-
ing.
” message will appear; then, a second “
Down-
load Success. Reset Done. Waiting for USB Cable
Disconnection.
”
Blue
Text Line will appear (Fig-
a
) during the Model information collec-
tion process.
16. Confirm that the Host’s Checksum and the Unit’s
Checksum identically match each other (Figure 6-
b
) after the LED starts flashing at a
Green
Color Rate.
Figure 6-16
Figure 6-16
Select Firmware 1
a
b
Figure 6-17
Figure 6-17
Select Firmware 2
b
a
Figure 6-18
Figure 6-18
Select Firmware 3
a
b
NOTE: All of the above steps are
explained in detail onscreen when “
Auto
”
is selected in the “Reset” Pull Down Menu.
Figure 6-19
Download Progress Screen
a
c
b
Figure 6-20
Figure 6-20
Download Progress Screen
a
