JCM ivision series, Integration Manual

CONFIDENTIAL PROPERTY OF JCM GLOBAL 

DRAFT 

5

 © 2010, Japan CashMachine Co, Limited

3

iVIZION™ Series Next-Generation Banknote Acceptor Integration Guide

2 SPECIFICATIONS

Technical Specifications  

Environmental Specifications 

Electrical Specifications

Table 1 

iVIZION Technical Specification

Banknote Types Accepted:

Long edge: 110-170 mm (4.33-6.69 in.)
Short edge: 60-85 mm (2.36-3.35 in.).

Barcode Coupon

*

*. Refer to the specific Country’s “Bar Code Coupon Specification” for more details.

Standard Specification

a) Read Code interleaved: 2 of 5

b) Narrow Bar: 0.5mm-1.0mm (0.19-0.23 in.)

c) Wide Bar: Narrow Bar = 3 : 1

d) Characters: 18 Characters

e) Print Position: Middle (by dividing a Coupon equally on the left, right, top and 

bottom of the Coupon’s exact center)

f) Print Width: Wider than 10mm (0.39 in.).

Insertion Direction:

Refer to the specific Country’s Software Information Sheet.

Processing Speed:

Approximately 2 seconds from Banknote insertion to Vend signal output.
Approximately 3 seconds from Banknote insertion to completion of the 

stacking operation.

Validation Method

Optical

Diagnostic Indicators:

Power LED, Status LED, Bezel LED (Optional)

Escrow:

1 Note

Cash Box Type

†

:

†. User supplied installed Locks (including the attached Plate, Lock and Key).

Secure Cash Box
Intelligent Cash Box (available with RF-ID Specification)

Cash Box Capacity

‡

:

‡. The number of Notes stacked depends on the Banknote’s condition.

Standard: 500 Banknotes
Large: 900 Banknotes.

Fraud Detection:

Equipped

Interface:

USB Interface: USB Specification Rev.2.0 Hi Speed Transfer (480 Mbps)
Serial Interface: Photo-Coupler Isolation
Serial Interface: RS232 Communication Protocol.

Table 2 

iVIZION Environmental Specification

Operating Temperature:

5º C to ~ +50º C (41º F to ~ 122º F)

Storage Temperature:

-20º C to ~ +70º C (-4º F to ~ 158º F) 

Relative Operating Humidity:

15% to ~ 85% RH (non-condensed)

Relative Storage Humidity:

15% to ~ 85% RH (non-condensed)

Installation:

Indoors Only

Table 3 

iVIZION Electrical Specifications

Supply Voltage:

12V DC (-10%) ~ 24V DC (+10%)

Current Consumption:

Standby: 24V DC = 0.2A, 12V DC = 0.2A
Operation: 24V DC = 1.3A, 12V DC = 2.3A
Maximum: 24V DC = 3.2A, 12V DC = 3.0A

Hydrothermal Condition Table

[°C]

[RH%]

Allowable Operating
Temperature and
Humidity Range

40°C/85%

60°C/40%