JCM ivision series, Integration Manual

CONFIDENTIAL PROPERTY OF JCM GLOBAL 

DRAFT 

5

 © 2010, Japan CashMachine Co, Limited

4

iVIZION™ Series Next-Generation Banknote Acceptor Integration Guide

Structural Specifications

This section provides installation and operating 

instructions for the iVIZION™ Series Banknote 

Acceptor Unit. The information within contains the 

following features:

•  Installation Process
•  DIP Switch Configurations
•  Connector Pin Assignments
•  Preventive Maintenance
•  Clearing Banknote Jam
•  Cleaning
•  Interface Schematic
•  Operational Flowchart

I

NSTALLATION

 P

ROCESS

Mounting holes are provided in each Frame Unit to 

attach the iVIZION™ to a related Machine during 

installation. Select and perform the following steps 

to install the iVIZION™ Unit:

1. Install 

the 

Interface 

Harness to the Frame 

Grounding Plate (FG PLT) (See Figure 4 a) using 

the two (2) Floating Collars (See Figure 4 b), the 

single (1) M2.6x12 W Washer (See Figure 4 c), 

the single (1) M2.6x10 W Washer (See Figure 4 

d) and the single (1) M2.6 Nylon Nut (See 

See Figure 4 e) to the Frame Assembly.

2.  When a side mounting configuration is preferred, 

bolt the left and right side of the iVIZION™ 

Frame into its intended location using six (6) M4 

Screws on both sides of the Frame (3 Screws on 

each side as shown in Figure 4).

3.  When an end mounting configuration is preferred, 

remove the Cash Box and bolt the rear end of the 

iVIZION™ Frame into its intended location using 

four (4) UNC6-32 Flat Head Screws from inside 

the back end of the Frame as shown in Figure 5.

When installing the 

iVIZION™

 Unit into the

 Host

Machine, refer to Figure 12 “iVIZION Installation 

and Maintenance Space Requirements Diagram” 

on page 9 of this document.

Table 4 

iVIZION Structural Specifications

Weight Empty:

Approximately 4.1kg (9.04 lbs)

Mounting:

Horizontal (Maximum gradient limitation within 50 degrees; See Figure 

12 on page 10)

Outside Dimensions:

Refer to “iVIZION Banknote Acceptor Unit Outside Dimensions” on 

page 8 of this document.

3 INSTALLATION

Installation Procedure

a

b

b

c
d

e

Figure 3 

Interface Harness Installation Location

Figure 4 

M4 Screws Locations (Left/Right Side)

Figure 5 

Flat Head Screws Locations (Rear Side)

NOTE: The length of the M4 Screws should 
be selected in order not to puncture the 
Plastic Surface of the iVIZION™ Frame 
when aside mounting configuration is 
preferred.