11
Pulse Communication
Pin No.
Signal Name
I/O *1
Function
1
NC
-
Not Connected
2
NC
-
Not Connected
3
ENABLE/
DISABLE (-)
4
ENABLE/
DISABLE (+)
5
VEND(-)
6
VEND(+)
7
VCC
-
12V DC Power Supply
8
VSS
-
Power Supply GND
9
NC
-
Not Connected
10
NC
-
Not Connected
IN
OUT
Enable/Disable Signal Input Line
(Enable when the current is applied.
Disable when the current is NOT applied.)
Pulse Signal Output Line
(Active when the current is applied.)
*1 Conditions for the I/O (Input/Output) column are from the acceptor side.
7-2-2. Interface Connector
01:Parallel(ID-001) Specification
The following diagram is the interface connector as viewed from the acceptor side or from a
relay board.
16PIN Connector
S16B-PADSS-1 (JST)
7-2-2-1.Interface Connector Pin Assignment
01:Parallel(ID-001) Specification
Pin No. Signal Name I/O *1
Function
1
VCC
-
12V DC Power Supply
2
VCC
-
12V DC Power Supply
3
VSS
-
Power Supply GND
4
NC
-
Not Connected
5
ACK
ACK Receive Line
6
REJ
REJ Receive Line
7
INH
INH Receive Line
8
VALID
VALID Send Line
9
VEND1
VEND1 Send Line
10
VEND2
VEND2 Send Line
11
VEND3
VEND3 Send Line
12
NC
-
Not Connected
13
NC
-
Not Connected
14
BUSY
BUSY Send Line
15
ABN
ABN Send Line
16
ST KF
ST KF Send Line
IN
OUT
OUT
*1 Conditions for the I/O (Input/Output) column are from the acceptor side.
Summary of Contents for TAIKO
