2-5
TAIKO Service Manual
© 2006 Japan Cash Machine Co., Ltd. All rights reserved.
CHAPTER
2
Pin No.
Signal Name
I/O *1
Function
1
NC
-
Not Connected
2
NC
-
Not Connected
3
RXD-
4
RXD+
5
T XD-
6
T XD+
7
Vcc
-
12V DC Power Supply
8
Vss
-
Power Supply GND
9
NC
-
Not Connected
10
NC
-
Not Connected
IN
OUT
Data Send Line
(Active when the current is applied)
Data Receive Line
(Active when the current is applied)
*1 Conditions for the I/O (Input/Output) column are from the Bill Acceptor side.
ID-003 (serial)/ MDB Communication
Pin No.
Signal Name
I/O *1
Function
1
NC
-
Not Connected
2
NC
-
Not Connected
3
Enable/Disable (-)
4
Enable/Disable (+)
5
Vend(-)
6
Vend(+)
7
Vcc
-
12V DC Power Supply
8
Vss
-
Power Supply GND
9
NC
-
Not Connected
10
NC
-
Not Connected
In
Out
Enable/Disable Signal Input Line
(Enable when the current is applied.
Disable when the current is NOT applied.)
PULSE Signal Output Line
(Active when the current is applied.)
*1 Conditions for the I/O (Input/Output) column are from the Bill Acceptor side.
Pulse Communication
1
15
16
2
2-2-2. Interface Connector
01: ID-001 (parallel) Specification
The following diagram is the interface connector as viewed
from the acceptor side or from a relay board.
16PIN Connector S16B-PADSS-1(JST)
Summary of Contents for TAIKO
