MOTOR INSTALLATION:
1. INSTALL YOUR PINON OF CHOICE ON THE MOTOR PRIOR TO INSTALLATION.
THE PINON GEAR WILL BE DETERMINED BY YOUR MOTOR SELECTION.
THE RECOMMENDED PINON FOR A 10 x 2 MODIFIED MOTOR IS A
20 TOOTH.
2. INSTALL YOUR MOTOR USING THE 3mm x 8mm SOCKET
HEAD SCREWS WITH A GOLD WASHERS ON EACH.
THREAD THE BOTTOM SCREW PARTIALLY INTO THE
MOTOR PRIOR TO INSTALLATION.
3. SET THE GEAR MESH SO THAT THE PINON GEAR AND THE
SPUR GEAR ROCK BACK AND FORTH A SMALL AMOUNT.
4. TIGHTEN THE SCREWS TO SECURE THE MOTOR.
3mm x 8mm
SOCKET HEAD SCREWS
WITH GOLD WASHERS
x 2
NOTE: IT IS HELPFUL TO HAVE A 2.5mm BALL END
HEX DRIVER FOR MOTOR INSTALLATION.
BODY FINISHING AND COMPLETED ASSEMBLY:
1. THE BODY COMES CLEAR. MASK AND PAINT THE INSIDE OF YOUR BODY AS DESIRED. WINDOW MASKS
ARE INCLUDED FOR YOUR CONVENIENCE. BE SURE TO USE A PAINT THAT IS SPECIFICALLY FORMULATED
TO ADHERE TO LEXAN.
2. CUT OUT THE BJ4 WORLDS EDITION BODY ALONG THE CUT LINES ON THE BODY USING LEXAN SCISSORS.
NEXT, DRILL OUT THE LOCATIONS FOR THE BODY MOUNTS AND ANTENNA. MOUNT THE BODY USING THE
INCLUDED BODY CLIPS. FOR A MORE SECURE ATTACHMENT, APPLY SOME HOOK AND LOOP TAPE TO
THE BODY MOUNT PADS AND BODY.
STEP 5
STEP 6
PAGE 28
TIRES, ELECTRICAL AND BATTERY PACK NOT INCLUDED.
BODY IN KIT COMES CLEAR. SOME DECALS SOLD SEPARATELY.
Summary of Contents for BJ4
Page 1: ......
