0
Instructions for Use
Testifier™ powers off automatically
minutes after the last button press in cable
testing modes and after . hours in tone
mode. Be sure to install a battery if using
for the first time, see battery installation
section.
Cable Testing
To Test a Patch Cable
(see caution about
cables with bad plugs above)
Plug one end of patch cable into main
unit.
Plug other end of cable into remote unit.
Press TEL or NTWK as appropriate for
the jack the patch cable is connected to.
The Testifier™ will turn on and begin a
test. If tester was already on, press TEL
or NTWK to initiate a new test. Results
are invalid if a cable is attached during
a test in progress.
To turn Testifier™ off, press COAX
button.
)
)
)
)
Summary of Contents for Testifier
