5
In the coax mode, the “Open”, “Short” or
“Pass” icon will be on to indicate the results
of a test. If the cable passes, the “ID” icon
will be on as well as a remote ID number, on
the bottom line of the display. The “Coax”
icon turns on when a test is in progress.
As mentioned above, the tone generator
operates in Telephone, Coax and Network
modes. The different modes are provided
so that the pins or pairs being driven with a
tone signal are displayed in terms of one of
the three connectors. The specific mode is
selected by pressing one of the cable test
buttons (TEL, COAX or NTWK) followed by
the TONE button. If the Testifier™ was off
when the TONE button is pressed, the last
cable test mode used will be selected. The
tone generator saves the driven pins for
each mode independently. For example,
selecting a different pin to drive in network
mode will not change the driven pin in coax
mode. Pressing any cable test mode button
will turn off the Testifier™ when in tone
mode.
Telephone (TEL) Cable Test Mode
The Testifier™ assumes the 6-position jack
on the main unit and the remote will be used
for connecting the tester to the cable run to
be tested. This mode uses the -pair USOC
Summary of Contents for Testifier
