12
The shims behind of rotors should be carefully maintained not
to be lost or damaged in order to use when assembling.
In order to remove stationary seals, both of seal stopper/pin
on the top and bottom should be loosened as shown.
Rotary seal rings are being installed into rotors with rotary
seal ring rubber cap.
Remove seals body from housing.
The seals can be easily moved forward by using minus (-)
driver as shown.
Fig. 4
Fig. 5
Fig. 6
Fig. 7
Fig. 8
Summary of Contents for AccuLAB Series
