7
SAFETY
DO’S & DON’TS
DO read and understand these instructions before installing or using the pump.
DO use JEC spare parts when replacing a component of the pump.
DO NOT services the pump while it is running.
DO NOT place the pump in an application where the service ratings are exceeded.
DO NOT modifies the pump. Modifying the pump creates unsafe conditions and voids all
warranties.
SAFETY PRECAUTIONS WHEN INSTALLING PUMP
DO use an authorized electrician when connecting the pump.
DO observe the mechanical limits of the pump (refer to the pump performance sheet).
DO install a throttling valve in the discharge line.
DO NOT installs a throttling valve in the suction line.
SAFETY PRECAUTIONS WHEN OPERATING PUMP
DO only qualified personnel should operate this pump.
DO NOT start the pump until all personnel are clear.
DO NOT touches the pump or the lines when pumping hot fluids or when performing
Clean In Place (CIP) procedures.
DO NOT run the pump with BOTH the suction inlet and discharge outlet blocked. Running
the pump with the inlet the blocked will cause serious damage to the pump.
DO NOT checks pump rotation with liquid in the pump.
DO NOT runs the pump with the front cover removed. The
screws and screw case
could
be damaged or may cause severe injury.
DO NOT operates the pump with removed the safety guard or shroud.
SAFATY PRECAUTIONS WHEN SERVICING PUMP
DO ensure the pump is cool to touch before performing service.
DO relieve all pressure and drain all fluids from pump and connected piping before
performing service.
DO ENSURE POWER TO THE UNIT HAS BEEN UNPLUGGED PRIOR TO
PERFORMING ANY PUMP MAINTENANCE OR CLEANING.
DO exercise caution and wear protective clothing when using lye or acid for cleaning.
Summary of Contents for AccuLAB Series
