Current instructions at www.jeco-inc.com
1-800-893-3006
Page 2 of 3
Step 3:
Insert the middle section of tree body (B) into the bottom of tree body (C),
then take the top section (A) of the tree and it into the middle section (B) of the tree.
To Assemble:
Before you start to assemble your tree, choose a location near a wall outlet.
Make sure the tree stand is placed on a level surface.
Step 1:
Choose a location near a wall outlet, insert the legs (D) of the tree stand
and lay the stand on the floor, slide the locking disk of the tree stand down until
it snaps into place.
Step 2:
Insert the bottom section of tree body (C) into the tree stand , tighten the
three thumb screws evenly and make sure the trunk stays straight.
