Flash Lights with Lock
The feature will cause the turn signal lights to flash
when the doors are locked or unlocked with the
RKE transmitter. This feature can be turned on or
turned off. To change the current setting, proceed
as follows:
•
For vehicles equipped with the Electronic Ve-
hicle Information Center (EVIC), refer to “Flash
Lights with Remote Key Lock,” under
"
Personal
Settings (Customer Programmable Features)”
under “Electronic Vehicle Information Center
(EVIC)” in Section 4 of this manual.
•
For vehicles not equipped with the EVIC, per-
form the following steps:
1. Press and hold the UNLOCK button on a
programmed (i.e., functional) RKE transmitter for
at least four seconds, but not longer than 10
seconds. Then, press and hold the LOCK button
while still holding the UNLOCK button.
2. Release both buttons at the same time.
3. Test the feature from outside the vehicle by
pressing the LOCK and UNLOCK buttons on the
RKE transmitter.
Repeat these steps if you want to return this
feature to its previous setting.
NOTE:
Pressing the LOCK button on the RKE trans-
mitter while you are inside the vehicle will
activate the VSA. Opening a door with the VSA
activated will cause the alarm to sound. Press
the UNLOCK button to deactivate the VSA.
To Unlatch the Liftgate Flip-Up
Window:
Press the rear RELEASE button twice to unlatch
the liftgate flip-up window.
WARNING!
To avoid injury stand back when opening. Glass
will automatically rise.
Programming Additional RKE
Transmitters
If you do not have a programmed RKE transmitter,
contact your authorized dealer for details.
Battery Replacement
The recommended replacement battery is
CR2032.
NOTE:
•
Do not touch the battery terminals that are
on the back housing or the printed circuit
board.
1. Remove the screw from the RKE transmitter
case (if equipped).
2. With the RKE transmitter buttons facing down,
use a flat blade tool to pry the two halves of the
RKE transmitter case apart. Make sure not to
damage the seal during removal.
3. Remove and replace the batteries. Avoid
touching the new batteries with your fingers. Skin
oils may cause battery deterioration. If you touch
a battery, clean it with rubbing alcohol.
4. To reassemble the RKE transmitter case, snap
the two halves together.
5. Reinstall and tighten the screw until snug (if
equipped).
Separating Case Halves
17
Summary of Contents for Cherokee 2009
