Enabling And Disabling The ParkSense Active
Park Assist System
The ParkSense Active Park Assist system can
be enabled and disabled with the ParkSense
Active Park Assist switch, located on the switch
panel below the Uconnect display.
To enable the ParkSense Active Park Assist
system, push the ParkSense Active Park Assist
switch once (LED turns on).
To disable the ParkSense Active Park Assist
system, push the ParkSense Active Park Assist
switch again (LED turns off).
When the ParkSense Active Park Assist system
is enabled the “Active ParkSense Searching -
Push OK to Switch to Perpendicular” message
will appear in the instrument cluster display.
You may switch to perpendicular parking if you
desire. Push the OK button on the left side
steering wheel switch to change your parking
space setting. You may switch back to parallel
parking if you desire.
For
further
information,
and
applicable
warnings and cautions, please refer to the
Owner’s Manual at www.mopar.com/en-us/care/
owners-manual.html
(U.S.
Residents)
or
www.owners.mopar.ca (Canadian Residents).
ParkSense Rear Or ParkSense
Front And Rear Park Assist — If
Equipped
• The four ParkSense sensors, located in the
rear fascia/bumper, monitor the area behind
the vehicle that is within the sensor’s field of
view.
• The six ParkSense sensors, located in the
front fascia/bumper, monitor the area in
front of the vehicle that is within the sensors’
field of view.
• The rear sensors can detect obstacles from
approximately 12 inches (30 cm) up to
79 inches (200 cm) from the rear bumper
while the vehicle is in REVERSE, while the
front sensors can detect obstacles from ap-
proximately 12 inches (30 cm) up to
47 inches (120 cm) from the front fascia/
bumper in the horizontal direction, depend-
ing on the location, type and orientation of
the obstacle. When an obstacle is detected,
a warning will display in the instrument
cluster and a chime will sound (when Sound
and Display is selected from the Customer
ParkSense Active Park Assist Switch
