© J e f f R ow l a n d d e s i g n g R o u p 2 0 07. a l l R i g h t s R e s e R v e d .
15
3) BYPASS INPUTS:
If the CAPRI is
installed in a home theater or sound system,
the Left Front and Right Front output connec-
tions from the surround processor should be
installed in the BYPASS input connections.
The CAPRI will only accept unbalanced RCA
interconnects from the surround processor.
NOTE:
If an external surround sound processor is not
connected, install RCA “shorting” plugs to both bypass
inputs.
(4) UNBALANCED LINE OUTPUTS:
The
CAPRI also has one pair of RCA unbalanced
line level outputs. Use these outputs if your
amplifier does not accept balanced inputs.
Also, these outputs can be used simulta-
neously with the balanced inputs to feed a
second amplifier (subwoofer, etc.)
NOTE:
Do NOT install RCA “shorting” plugs in the unbal-
anced line outputs.
(2) BALANCED INPUTS:
If you are using
balanced XLR interconnects from your
source components, they should be
con nect ed to balanced INPUTS 3 and 4. A
slight mechanical click may be heard when
the balanced XLR interconnect cables are
correctly installed and locked into the rear
panel connector. The unlocking tab must
be pressed to disconnect the XLR intercon-
nect cable from the preamplifier. The XLR
inputs may be left open if unused. Any XLR
input can be converted to an RCA input by
installing an XLR to RCA adapter, available
from your JRDG dealer.
NOTE:
Pin 2 of each XLR connector is signal positive
with respect to each RCA input. Also, JRDG recom-
mends balanced cables as the preferred method of
interconnection.
(5) BALANCED LINE OUTPUTS:
The CAPRI
has one pair of balanced preamplifier line level
outputs. For best results, use these outputs to
connect to your power preamplifier whenever
possible. If two sets of single-ended outputs
are required then the balanced line outputs can
be converted to single-ended RCA outputs.
JRDG recommends a single-ended adaptor
box (Model PC-2XR) available from Jensen
Transformers, www.jensen-transformers.com.
NOTE:
Pin 2 of each XLR connector is signal positive with
respect to each input and each unbalanced output.
(6) GROUND LUG THUMBSCREW:
This
connection is reserved for units with the
optional phono section installed. When
connecting a turntable, the ground or earth
lead should be connected to the Ground
Lug Thumbscrew to eliminate any ground
noise in the system.
