P O B OX 7 2 3 1 , C O LO R A D O S P R I N G S , C O LO R A D O 8 0 9 3 3 U S A E - m A I L : j R D G @ j E f f R Ow L A N D . C O m w w w. j E f f R Ow L A N D . C O m T E L E P H O N E ( 7 1 9) 47 3 -1 1 8 1
22
j1
J2
FIGURE 4:
Location of jumpers on back of the rear panel
FIGURE 5:
Jumpers J1-J2; Close-up of Remote Control Frequency settings for the CAPRI
REMOTE CONTROL FREqUENCY
A second remote control opera-
tional frequency may be selected
for the CAPRI if interference occurs
when using the factory-default
settings. This interference could
occur either from the CAPRI’s
remote interfering with other equip-
ment or vice versa.
STEP 1:
Unplug the CAPRI power
cable from the wall AC outlet.
STEP 2:
Place the unit upside-
down on a soft, clean surface.
Using a 5/64" hex wrench,
remove the nine screws that
secure the bottom cover.
REMOTE FREqUENCY STANDARD
(DEFAULT)
REMOTE FREqUENCY ALTERNATE
J2
j1
jUMPERS
DEFAULT POSITIONS SHOWN
1 2 3
1 2 3
O P T I O N A L A d j u s T m e N T s
OW N E R ’ S M A N UA L
C A P R I /C A P R I S S T E R EO P R E A M P L I F I E R