Low output Moving Coil cartridges (LOMC) -position 1 and 2
ON
Standard Moving Coil cartridges (MC) -position 3 and 4
ON
High Output Moving Coil cartridges -position 5 and 6
ON
Moving Magnet cartridges -position 7 and 8
ON
Two RCA interconnect cables are provided to connect between
the audio source component and selected CONDUCTOR input.
Connect the chosen source component output to the Network
RCA inputs labeled R IN and L IN with one supplied RCA cable.
Use the other supplied RCA cable to connect the Network R
OUT and L OUT RCA outputs to any active right and left channel
CONDUCTOR RCA input jacks.
Turn on the source component with a verified signal, then turn on
the CONDUCTOR and choose the selected active input. Monitor
the CONDUCTOR outputs with a connected preamplifier to
verify that the source signal is present. The source component can
be left on, providing a constant “break-in” signal whenever the
phono turntable is not being used, to facilitate a complete break-
in of all internal circuitry of the CONDUCTOR. Expect dramatic
improvements of the CONDUCTOR sonic performance after 400
hours or more of “break-in” using this Inverse RIAA network.
!
22
