© J e f f R ow l a n d d e s i g n g R o u p 2 0 0 9 . a l l R i g h t s R e s e R v e d .
23
STEP 7:
Test the remote with the CONTINUUM
Integrated Amplifier to make sure that the
units operate properly together.
STEP 8:
After verifying proper operation,
replace the remote housing and reinstall the
two screws that secure the housing.
STEP 3:
Locate jumper position J1 on the
rear panel board of the unit. Using needle-
nose pliers, move the jumper from between
pins 1 and 2 to pins 2 and 3. (See FIGURES
4 and 5)
STEP 4:
Replace the bottom cover. Using
a 5/64" hex wrench, reinstall the nine
screws that secure the bottom cover to the
CONTINUUM chassis.
STEP 5:
Using a #1 Phillips head screw-
driver, remove the two screws that secure
the remote transmitter housing. Open
the housing.
STEP 6:
Locate switch position SW7.
Adjust slider #1 on the switch. This switch
now corresponds with the new setting on
jumper J1 of the rear panel board.
SWITCH SW7
FIGURE 6:
Remote transmitter housing
with details of switch position SW7
FIGURE 7:
Detail of switch
position sw7
SWITCH SW7 POSITION 1
(DEFAULT)
SWITCH SW7 POSITION 2
1
ON
2
1
ON
2
