3
USER MANUAL
JEFJKBTL05C
HYDRAULIC BOTTLE JACK
www.jeffersontools.com
WARNING! BEFORE LIFTING ENSURE SECTION 1 SAFETY INSTRUCTIONS
ARE STRICTLY FOLLOWED.
• Before using the jack, purge the hydraulic system to eliminate any air that may
have accumulated during transit, as follows:
a) Fit jack handle over release valve (Fig. 1.1) and turn anti-clockwise
to open valve.
b) Insert jack handle into the handle sleeve and pump several times
to ensure full internal lubrication and to bleed air from the system.
c) Fit jack handle back over the release valve and turn clockwise
to close.
LIFTING
WARNING! ENSURE YOU PREPARE VEHICLE AND USE JACK ACCORDING TO SECTION 1 SAFETY INSTRUCTIONS.
• Check that the ground upon which the jack will stand is level and solid.
• Position the jack saddle under the vehicle manufacturer’s recommended lifting point. Position jack so as to avoid having to
operate it from under the vehicle and so that the handle can be moved up and down without hitting any part of the vehicle.
• Using the screw extension as necessary, raise the saddle to the lifting point. Ensure that the saddle is correctly centred
beneath the lifting point.
• Pump the handle up and down using full stroke until the required lift is achieved.
• Should the jack become overloaded, a safety overload valve will open, and stop the vehicle from lifting.
• Lower the vehicle onto suitable axle stands before attempting any work.
LOWERING
• Ensure that the axle stands are removed and that there are no persons or obstacles beneath the vehicle,
or in the path of its descent.
• The lowering speed is controlled by the amount the release valve is opened.
Turn valve anti-clockwise and lower slowly and carefully.
2. Features
3. Specification
4. Operation
Model Number: JEFJKBTL05C
Weight: NW: 4.5Kg / GW: 5.3Kg
Capacity: 5 Tonne
Adjustment Range: 70mm
Minimum Height: 216mm
Maximum Height: 413mm
• Heavy-duty steel construction provides stability and endurance
• High quality, large diameter, hydraulic steel cylinder unit resulting in lower oil pressure needed to raise the load for
reduced wear & tear and extended service life
• High-quality, oil-powered hydraulics ensure corrosion resistance and high/low temperature flexibility with 194-372mm lifting range
Warning: This equipment is designed for lifting purpose only, always use axle stands and wheel chocks to support the vehicle.
FIG. 1
1. Release Valve
2. Handle Sleeve
3. Ram
4. Saddle
5. Overload Valve
(Do Not Adjust)
