10
USER MANUAL
JEFMIG185-A – JEFMIG210-A
185A MIG WELDER - 230V 50Hz
210A MIG WELDER - 230V 50Hz
www.jeffersontools.com
The following summary provides a brief overview of the front switch panel (see
Fig.14
). If you have any additional questions
relating to the equipment please contact your nearest Jefferson Dealer before using the equipment.
5.1. “ON/OFF” switch
When the switch is in the “OFF” position it means power has been shut off to the welder, when the switch is in the ”ON”
position it means power is supplied to the main transformer and control circuit.
5.2. Voltage Setting switch
The voltage setting switch is on the front panel of the machine. There are six settings, allowing you to choose the correct
voltage level for the thickness and type of metal being welded.
5.3. Wire speed control knob
Used to control the wire speed: turn clockwise to increase the wire speed or counter-clockwise to decrease the wire
speed. The numbers (0-10) around the knob show the wire feed speed. The rated wire feed speed for this equipment is
1.8m/min ~ 11.6m/min.
5.4. Overload light
If you are welding with a large current for a long time and exceed the duty cycle, the overload lamp will light (yellow), and
the welder will automatically shut down until it cools down. If this happens, you must stop welding and wait
approximately
10 minutes,
before the unit will reset and allow you to continue welding.
5. Equipment Overview
Fig.14
Front Switch Panel
OVERLOAD LIGHT
VOLTAGE SETTING
SWITCH
"ON / OFF"
SWITCH
POWER CORD
WIRE SPEED
CONTROL KNOB
WELDING TORCH
SOCKET
GROUNDING
CABLE
Summary of Contents for JEFMIG185-A
Page 1: ...User Manual v 1 1 JEFMIG185 A JEFMIG210 A...
Page 2: ......
