www.jeffersontools.com
User Manual
v.1.1
JEFPDB0350
10. OPERATION
TURNING ON AND OFF
Fig.42
Note: The pulley cover must be closed to operate the drill press.
1. Switch the drill press On by pressing the green(I)button on the switch (Fig.42-43).
2. Switch the drill press Off by pressing the red(O)button on the sw itch.
3. Secure your workpiece to the table if possible,use a vice or clamps.
DRILLING
1. Ensure the drill press is switched off and disconnected from the power supply.
2. Loosen the jaws of the chuck with the chuck key by turning in an anti-clockwise direction and
insert the selected drill bit into the as far as it will go.
3. Insert the chuck key into 1 of the 3 locating holes and tighten until drill bit is secure.
4. Select your drilling depth and secure the depth stop lock knob in position.
5. Adjust the table to your desired position.
6. Slowly rotate the feed wheel handles to bring the drill bit down towards the table and into your workpiece. After drilling a hole, release the feed
wheel handles slowly to return the chuck to its original position.
7. Continue the operation until the task is completed. When completed, switch the drill press Off by pressing the red (O) button on the switch.
Fig.43
