9
USER MANUAL
V1.2
JEFSWMIT12-110
•
JEFSWMIT12-230
305mm
SLIDING COMPOUND MITRE SAW
3.5 General Safety Warnings for your Laser
1
.
WARNING
: Read all safety warnings and all instructions. Failure to follow the warnings and instructions may result in serious injury.
2.
Save all warnings and instructions for future reference.
3.
These lasers do not normally present an optical hazard although staring at the beam may cause flash blindness.
4.
Do not stare directly at the laser beam. A hazard may exist if you deliberately stare into the beam, please observe all safety rules as
follows:
5.
The laser shall be used and maintained in accordance with the manufacturer’s instructions.
6.
Never aim the beam at any person or an object other than the work piece.
7.
The laser beam shall not be deliberately aimed at another person and shall be prevented from being directed towards the eye of a person
for longer than 0.25 seconds area.
8.
Always ensure the laser beam is aimed at a sturdy work piece without reflective surfaces, e.g. wood or rough-coated surfaces are
acceptable. Bright shiny reflective sheet steel or similar is not suitable for laser applications as the reflective surface may direct the laser
beam back at the operator.
9.
Do not change the laser device with a different type. The manufacturer or an authorized agent must carry out repairs.
10.
CAUTION: Use of controls or adjustments other than those specified herein may result in hazardous radiation exposure.
The laser device fitted to this tool is CLASS 2 with a maximum radiation of <1mW and 650nm wavelength. Do not stare into the
beam
4. Unpacking & Assembly
Due to modern mass production techniques, it is unlikely that your Power tool is faulty or that
a part is missing. If you find anything wrong, donot operate the tool until the parts have been
replaced or the fault has been rectified. Failure to do so could result in serious personal injury.
1.
Remove all loose parts from the carton.
2.
Remove the packing materials from around the saw.
3.
Carefully lift the saw from the carton and place it on a level work surface.
4.
The saw has been shipped with the saw head locked in the down position.
To release the saw head, push down on the top of the saw arm, pull then turn the the saw head
release knob (A)
Fig.1
WARNING:
Do not lift the saw while holding on to the guards. Ue the top mounted carrying
handle.
Mitre Angle Lock Handle
The saw is supplied almost fully assembled, you should assemble the mitre lock handle (A)
Fig.2
first. Attach the mitre handle by screwing it into position as shown. This handle is used to lock or
unlock the table at the desired mitre angle. Once the mitre angle is set, use the mitre lock handle
to lock the table.
Fig.1
Fig.2
Summary of Contents for JEFSWMIT12-110
Page 2: ......
Page 22: ...22 USER MANUAL V1 2 JEFSWMIT12 110 JEFSWMIT12 230 305mm SLIDING COMPOUND MITRE SAW NOTES...
Page 23: ......
