1-800-345-4545
Charging/Discharging/Cycling
NiMH & NiCd Batteries
To charge, discharge or cycle
(charging & discharge) a NiMH or NiCd
battery, press the BATT TYPE/STOP
button until the screen shows NiMH/
NiCd Battery Mode and then press
START/ENTER.
The screen is broken up into four
quadrants and the value in each
quadrant is adjustable allowing the
charger to be configured for charging,
discharging and cycling modes for
both NiMH and NiCd batteries. Before
proceeding be sure to confirm the
appropriate settings for your battery
as recommended by the battery
manufacturer.
To change the first quadrant’s value
press the START/ENTER button and
the value will begin to flash. Change
the value by using the INC (increase)
or DEC (decrease) button. Pressing
the START/ENTER button once more
will cause the next quadrant value to
flash and this can be changed in the
same way. When the final selection for
quadrant 4 has been made press the
START/ENTER button once more. At
this point no value should be flashing
and this information has been saved.
Unless these settings are later adjusted,
the next time the charger is used these
settings will automatically be recalled
with the default mode being charge.
Continued onto next page.
13
Display
NiMH CHARGE
CURRENT
2.0A
Quadrant 1
Quadrant 2
Quadrant 3
Quadrant 4
CHARGE
MODE
Display
NiMH
DISCHG
2.0A
6.0V
DISCHARGE
MODE
Quadrant 1
Quadrant 2
Quadrant 3
Quadrant 4
Display
NiMH
CYCLE
CHG/DCHG 1
CYCLE
MODE
Quadrant 1
Quadrant 2
Quadrant 3
Quadrant 4
