User Maintenance Instructions
Procedures not specifically explained in this manual must be performed only by a qualified technician.
WARNING!
TO PREVENT SERIOUS INJURY FROM ACCIDENTAL OPERATION:
Tum off the tool, detach the air supply, safely discharge any residual air pressure in the tool, and release the trigger
before performing any inspection, maintenance, or cleaning procedures.
TO PREVENT SERIOUS INJURY FROM TOOL FAILURE:
Do not use damaged equipment. If abnormal noise, vibration, or leaking air occurs, have the problem corrected before
further use.
Cleaning, Maintenance, and, Lubrication
Note:
These procedures are in addition to the regular checks and maintenance explained as part of the regular
operation of the air-operated tool.
1. Daily
– Air Supply Maintenance:
Every day maintain the air supply according to the component manufactures’
instructions. Drain the moisture filter regularly. Performing routine air supply maintenance will allow the tool to operate
more safely and will also reduce wear on the tool.
2. After use, empty the Cabinet Funnel of blast media:
CAUTION!
Wear ANSI-approved Safety Goggles and NIOSH-
approved dust mask/ respirator when emptying the abrasive media.
a. Place a container (sold separately), which is large enough to hold all the blast media, under the mouth of the
Funnel.
b. Tum the handle on the Funnel Mouth to open the Funnel and allow all the abrasive media to flow into the
container.
c. Close the Funnel Mouth
1-800-345-4545 jegs.com
