CHARGING & RECHARGING INSTRUCTIONS
CAUTION
•
Ensure that the unit power push-button is in the off position.
•
This product may arrive partially charged from the manufacturer. It is recommended to fully charge the unit
immediately after purchase and before using for the first time.
•
Recharge immediately when red LED (25%) is flashing due to jump starter battery low voltage. Fully recharge the
jump starter, when charge status is 50%. Once unit is 100% charged, all LEDs lights will turn off. To check status,
press power push-button one time.
•
The charging LED indicators will be illuminated while charging, showing 25%, 50%, 75%, & 100%.
•
It is recommended that the jump starter is in an upright position while charging.
2.
IMPORTANT:
THE 120 VOLT AC POWER UNIT (CHARGER) IS INTENDED TO BE CORRECTLY ORIENTED IN A
VERTICAL OR FLOOR MOUNT POSITION DURING CONNECTION TO A 120V AC RECEPTACLE.
3.
NOTE:
ENSURE BOTH BOOSTER CLAMPS (POSITIVE & NEGATIVE) ARE PLACED IN THEIR STORAGE
HOLDERS WHEN NOT IN USE & DURING THE JUMPSTARTER RECHARGING.
CHARGING WITH 120 VOLT AC CHARGER
1. Insert the 120V AC charger plug into the jump starter charging port.
4.
2. Insert the 120V AC charger transformer plug into a 120V AC receptacle.
5.
3. Fully charge the unit according to the following:
Initial & first time charge: charge until LED charge status lights turn off.
Recharge or between each use: 6 to 8 hours.
4. Charging LEDS will turn off once 100% status is achieved. Press power push-button to verify 100% charging status.
When charging is complete unplug the 120V AC charger transformer plug first and then the 120V AC charger plug from
the charging port on the jump starter.
SPECIFICATIONS
1. BUILT IN BATTERY: 33 AMP HOUR (Ah) LITHIUM COBALT BATTERY
2. STARTING CURRENT: 12V/700A : 24V/350A
3. PEAK CURRENT: 12V/1400A : 24V/700A
4. USB PORT: 5V DC/ 2.4A
5. LED LIGHT: 12V DC/ 2 LED (2W/330mA)
6. PROTECTIONS: OVER CURRENT, LOW VOLTAGE, OVER & REVERSE CHARGE, REVERSE POLARITY,
OVER TEMPERATURE, SHORT CIRCUIT
7. OPERATING TEMP: -40° F - 1400° F
8. NET WEIGHT: 6.8 1b
9. UNIT DIMENSIONS: 9.5" (H) x 10.6" (W) x 5" (D)
STORAGE
Store in cool, dry, well ventilated area with overhead cover. This unit may be stored in any position. Ensure that the
booster clamps are secured to their storage holders.
NOTE:
Jump starter output & power buttons must be in the off positions. If not used for prolonged time, recharge every
3 months.
1-800-345-4545 jegs.com
