9. If the vehicle starts, disconnect clamps in reverse sequence to connecting procedure above as far away
from the vehicle battery as practical:
For Negative Grounded System
first disconnect Negative (-) Black clamp then Positive (+) Red clamp.
For Positive Grounded System
first disconnect Positive (+) Red clamp then Negative (-) Black clamp.
10. Replace the clamps to their storage holders.
NOTE:
12V or 24V LED output indicators will turn off after use automatically.
LED LIGHT & EMERGENCY FLASHER INSTRUCTIONS
1. To power on the LED light, press & hold the power push-button until LED display illuminates, then
release. Double-click on button to turn light on.
2. Press the push-button switch once to activate the emergency flasher function.
3. Press the push-button switch once to activate the SOS function.
4. To power off the light press & hold the power push-button until lights turn off.
NOTE:
LED light, emergency flasher & SOS functions will operate in sequence to each other. The lighting mode will
depend on the prior (last) operating function selected. User may have to cycle between modes in order to achieve the
proper lighting function.
USB POWERED DEVICES
1. Prior to connecting the device to the unit's USB port, make sure the device is off.
2. Using the power/charging cable included with the device to be powered or charged, connect the device to
the USB port on the jump starter.
3. Press & hold the power push-button until LED display illuminates. (The device with built-in battery will start charging
automatically). Turn on the device & use as normal.
4. Once finished charging device, unplug cable from USB port & press power push-button until LEDs turn
off.
NOTE:
Make sure device power/charging cable works prior to use. Make sure all connections are correct to USB port
and device port.
1-800-345-4545 jegs.com
