20
Changing Oil
• Run the generator until the engine is warm, then
shut OFF.
• Place generator on a firm and level surface,
raised on blocks for easier access.
• Remove the crankcase dipstick.
• Place an oil pan underneath the oil drain hole to
collect used oil.
• Remove the oil drain plug and allow oil to drain
completely.
• Reinstall oil drain plug, tighten securely.
• Carefully add SAE 30 or 10W-30 engine oil to
empty reservoir until the oil reaches the threads
of the oil fill hole (Crankcase Dipstick hole).
• Replace crankcase dipstick.
Oil Specifications
• Recommended Engine Oil:
SAE 10W-30
• Recommended Engine Oil Grade:
API Service Type SE or higher engine oil
• Engine Oil Quantity:
20.2 oz. (0.6 L)
Oil Recommendations
• Do not use special additives.
• Outdoor temperatures determine the proper oil
viscosity for the engine. Use the chart to select
the best viscosity for the outdoor temperature
range expected.
Do not tilt generator when adding oil. This
could result in overfilling which could
damage the engine. Make sure no foreign
matter enters the crankcase.
Air Filter
A dirty air filter will reduce the lifespan of th engine,
make it difficult to start and reduce performance.
Replace with a new filter annually.
• To clean, remove the screws then remove left
outer casing.
• Turn the spring latches to lift then open air filter
cover.
• Remove the pleated paper filter
• Blow the dust away with a compressed air
• Reinsert the paper filter into the air filter case.
Maintenance Cont.
Do not run the generator without reinstalling
the foam element or excessive piston and
cylinder wear may result, or excessive engine
wear may result.